The application of system dynamics in different practices of a waste management system

The continuous increase in waste generation warrants global management of waste to reduce the adverse economic, social, and environmental impact of waste while achieving goals for sustainability. The complexity of waste management systems due to different waste management practices renders such systems difficult to analyze. System dynamics (SD) approach aids in conceptualizing and analyzing the structure, interactions, and mode of behavior of the complex systems. The impact of the underlying components can therefore be assessed in an integrated way while the impact of possible policies on the system can be studied to implement appropriate decisions. This review summarizes various applications of SD pertinent to the waste management practices in different countries. Practices may include waste generation, reduction, reuse/recovery, recycling, and disposal. Each study supports regional-demanding targets in environmental, social, and economic scopes such as expanding landfill life span, implementing proper disposal fee, global warming mitigation, energy generation/saving, etc. The interacting variables in the WMS are specifically determined based on the defined problem, ultimate goal, and the type of waste. Generally, population and gross domestic product can increase the waste generation. An increase in waste reduction, source separation, and recycling rate could decrease the environmental impact, but it is not necessarily profitable from an economic perspective. Incentives to separate waste and knowledge about waste management are variables that always have a positive impact on the entire system.

     

Comparison of different sequential extraction procedures for mercury fractionation in polluted soils

Environmental Science and Pollution Research - Three sequential extraction procedures (SEPs), modified Tessier, modified BCR, and CIEMAT, were compared for mercury fractionation in polluted soils....     

试论生态文明制度体系的构建

建立健全生态文明制度体系是推进我国生态文明建设的重点。党的十八届三中全会通过的《中共中央关于全面深化改革若干重大问题的决定》指出,生态文明制度体系应当包括决策制度、评价制度、管理制度与考核制度等内容。立足社会主义制度建设的中国特色,针对我国生态文明建设的具体需求,本文将生态文明制度体系解构为四大板块:绿色高效决策制度、生态有价评估制度、生态环境监管制度与生态优先考核制度,并进一步明确了各项制度构建工作的具体内容。生态文明制度体系的构建和不断完善,将为全面建成人与自然和谐的美丽中国提供系统保障。     

离子色谱法测定PM_(2.5)中硫酸根离子含量不确定度评议

准确测定大气颗粒物中水溶性组份对分析污染物来源及身体健康具有重要意义。本文采用离子色谱法测定PM2.5中硫酸根离子含量,并对测定的不确定度进行分析。分析过程不确定度来源是样品重复性测量引入不确定度,样品测量准确性引入不确定度和标准曲线的不确定度。应用不确定度评定理论,计算硫酸根离子的合成不确定度。结果表明,滤膜中硫酸根离子本底浓度高低与剪裁滤膜环节是不确定度的主要来源。为了提高分析的准确性,建议使用本底低的滤膜,并取整张滤膜进行分析。     

珠江口表层水中多环芳烃的分布特征及健康风险评估

分别于2015年2、5、8、11月在珠江八大入海口采集表层水体样品,应用固相萃取富集法对该区域表层水体中16种USEPA优控多环芳烃(PAHs)的时空分布特征进行分析,并利用终生致癌风险增量模型(ILCR)对该区域的饮水健康风险进行评价。结果表明:珠江口4个季度所采集的水样中,∑15PAHs的浓度范围为18.0~50.3 ng/L,含量处于中等水平。其中7种强致癌性∑7PAHs的浓度范围为1.53~3.73 ng/L,占∑15PAHs的5.89%~11.1%,∑15PAHs和∑7PAHs在枯水期(2、11月)样品中明显高于丰水期(5、8月)。就组成特征而言,各采样点PAHs以3、4环为主。珠江口表层水中非致癌类PAHs的危害商数值为0.99×10~(-5)~2.73×10~(-5),远低于USEPA规定的阈值(1);致癌类PAHs产生的健康风险为6.50×10~(-8)~2.37×10~(-7),其中Ba P导致的饮水途径健康风险最高,所有点位致癌类PAHs的健康风险均低于USEPA推荐的对致癌物质最大可接受风险水平(10~(-6)),表明珠江口表层水中PAHs尚不具备严重的致癌风险,但是仍然存在潜在的健康风险,需要重点控制和管理。     

不同培养条件下锰过氧化物酶(MnP)的合成及其对甲基橙的降解

高效、大规模、低成本合成木质素降解酶是直接采用其降解难降解有机污染物所必须解决的问题.对锰过氧化物酶(MnP)降解甲基橙和在非灭菌的反应器中连续合成MnP的可行性进行考察.结果表明,在采用2 mmol H2O2和1.5 mmol MnSO4的降解体系中,获最大脱色效果,且100、200和300 U/L的MnP可在8h内将甲基橙分别脱色18％、23％和35％;在非灭菌的反应器水平上实现了固定化培养的P.chrysosporium连续23 d合成MnP,但MnP酶活仅为2～ 23 U/L,难以酶解甲基橙;然而,在摇瓶培养条件下固定化的P.chrysosporium合成的MnP却能达1 152 U/L.因此,直接采用MnP对污染物进行降解以及在非灭菌的反应器中持续合成MnP是可行的,但就在非灭菌条件下如何提高MnP的合成量还有待开展深入的研究.     

燃煤电厂海水烟气脱硫工艺原理初探

海水烟气脱硫工艺是利用天然的纯海水（燃煤电厂可直接利用电厂的冷却循环水）作为烟气中ＳＯ２的吸收剂，无需其它任何添加剂，也不产生任何废弃物，具有技术成熟、工艺简单、系统运行可靠、脱硫效率高（理论脱硫效率可达９８％）和投资运行费用低等特点，目前在一些国家和地区已得到日益广泛的应用。本文是在部分模拟试验的基础上，对海水烟气脱硫工艺进行了简单的阐述。     

Distribution of elements in needles of Pinus massoniana (Lamb.) was uneven and affected by needle age

Macronutrients (P, S, K, Na, Mg, Ca), heavy metals (Fe, Zn, Mn, Cu, Pb, Cr, Ni, Cd,) and Al concentrations as well as values of Ca/Al in the tip, middle and base sections, and sheaths of current year and previous year needles of Pinus massoniana from Xiqiao Mountain were analyzed and the distribution patterns of those elements were compared. The results indicated that many elements were unevenly distributed among the different components of needles. Possible deficiency of P, K, Ca, Mn and Al toxicity occurred in needles under air pollution. Heavy metals may threaten the health of Masson pine. Needle sheaths were good places to look for particulate pollutants, in this case including Fe, Cu, Zn, Pb, Cr, Cd and Al.     

Ambient air monitoring of PCDD/Fs and co-PCBs in Gyeonggi-do, Korea

We started the monitoring for PCDD/Fs in ambient air and soil in August 2001, and co-PCBs in January 2002. Decreasing of PCDD/Fs and co-PCBs levels in ambient air were observed. The higher PCDD/Fs levels were found in winter and lower in autumn. We found that the industrial incinerators influenced the PCDD/Fs levels in ambient air. In the 2,3,7,8-substituted PCDD/Fs concentration profiles, the three major congeners occupied 67% of the total mass. In case of co-PCBs, PCB#118, #105 and #77 were observed as the main congeners. Five cluster groups discriminated by ratio of four components, O(8)CDD, 1,2,3,4,6,7,8-H(7)CDD, 1,2,3,4,6,7,8-H(7)CDF and O(8)CDF, were obtained from HCA (hierarchical cluster analysis).